Krups Espresseria Automatic EA80 Series, Manual

Page: 24 / 187

19
ENGLISH
now prepared your appliance. The drink select menu will be displayed.
Put two cups under the coffee outlets. You can lower or raise the coffee outlets to suit the
size of your cups.-
Fig. 17
. Select your drink and confirm by clicking twice on the
OK
key.
A message will appear to tell you that you have chosen two cups.
The appliance will automatically sequence 2 complete coffee-making cycles.
PREPARING HOT WATER
While the screen displays the drink selection menu, press the “hot water” key .
A message will invite you to place a container under the steam nozzle. Again press the “hot
water” key to produce hot water -
Fig. 14 .
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum amount of hot water per cycle is limited to 300 ml.
PREPARING STEAM
Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats
up liquids. As you need a higher temperature to produce steam than to make an espresso,
the appliance runs an additional pre-heating phase for steam.
While the screen displays the drink selection menu, press the “steam” key -
Fig. 18 . A
screen will inform you that the appliance is being pre-heated. Once the pre-heating phase
has been completed, a message will ask you to place a container under the steam nozzle
-
Fig. 5 . Press the “steam” key again to start generating steam. A little water will be
produced first and then steam will start. Use the same key to stop steam generation.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.
Frothing milk
We recommend that you use pasteurised or UHT milk that has been recently opened.
Do not use untreated milk. After the steam function has been used, the nozzle will be
hot, and we recommend that you wait for a few moments before handling it.
Check that the steam nozzle is correctly fitted - Fig. 19 .
Pour the milk into your milk jug. Only half fill it. Immerse the nozzle in the milk - Fig. 20 .
Press the “steam” key and follow the instructions on the screen.
Once your milk is frothy enough… -
Fig. 21 , again press the “steam” key to stop the
cycle. Be careful, because the cycle does not stop immediately.
To remove any remaining milk from the steam nozzle, place a container under the nozzle
and press the “steam” key . Let the hot water escape for at least 10 seconds and then
again press the “steam” key to stop water.
You can remove the steam nozzle for thorough cleaning. Wash it using a brush with water
and a little non-abrasive washing up liquid. Rinse and dry it -
Fig. 22-23 . Before re-fitting,
make certain that the air inlet holes are not clogged by milk residues. Clean out the holes
with a needle if necessary -
Fig. 24 .