Krups CONTROL KM442D50, Manual

Page: 6 / 26

4
CLEANING
„ „
Unplug the appliance.
„ „
Let the appliance cool down before cleaning it.
„ „
To remove the filter holder, make sure that it is in the correct position ( Fig. 7 ).
„ „
Throw the coffee grounds into the garbage ( Fig. 8a and Fig. 8b ).
„ „
Clean with a damp cloth or sponge.
„ „
Place the ground coffee directly inside the permanent filter or the paper filter. The
filter holder has 2 positions - open and closed. Make sure that the filter holder has
been properly locked: the arrow and the lock icon must be facing each other. After
use, throw away the coffee grounds and rinse the filter holder under running water.
„ „
The recommended amount of coffee grounds is a level teaspoon (provided) for
standard grounds (do not exceed 10 spoons).
Note : The quantity of coffee brewed will be less than the quantity of water poured into
the coffee machine; approximately 10% of this water will be absorbed by the ground
coffee and filter.
Your coffee maker is equipped with an automatic stop system.
„ „
The appliance will stop automatically approximately 30 minutes after the end of the
cycle.
„ „
The appliance may also be switched off at any time by pressing the « » button (h).
Manual mode:
„ „
Press the « » button (h), the light will turn on and there will be a “beep” to signal
that the coffee maker has started up.
„ „
To stop the coffee maker, again press the « » button. The light will turn off and
there will be two “beeps”.
Programming mode Fig. 11 and 12:
„ „
Your appliance is equipped with two programming buttons , allowing you,
for example, to set one time during the week and another at the weekend. The two
programming buttons function in the same way.
„ „
Press the or , button and the timer will start to flash. If no setting is selected
within 10 seconds, the timer will go back to the current time.
„ „
Enter the time using the “H” (hours) and “MIN” (minutes) buttons. If no other action
is taken, the time entered will be automatically saved after approximately 5 seconds.
The timer will then go back to the current time.
„ „
Once programming is complete, the button used will remain lit.
„ „
You can check or change the programming time whenever you like by once again
pressing the
or button.
„ „
At the programmed time, the coffee maker will turn itself on. Buttons or and
« » will light up.
WARNING: The set program is automatically deactivated at the end of the coffee cycle;
however, the set time is saved. Reactivate the set program every day by pressing on the
button
or . In order to set a different time, please refer to paragraph “Using the
appliance in the Program Mode”.
„ „
Press the « » button to stop the cycle.
„ „
You can cancel the programming at any time by pressing buttons or for more
than 2 seconds.