Krüger & Matz KM9999, Owner'S Manual

Page: 4 / 13

Owner’s manual Owner’s manual
6 7
EN EN
Programming TV control buttons
1. Place the tuner remote and the TV remote towards each
other, within approx. 4 cm distance.
2. Press and hold the SET button, until the red LED glows
stronger.
3. On the tuner remote, press one of the programmable
buttons (in the TV CONTROL frame).
4. Press the corresponding button on the TV remote a
couple of times.
5. Press the SET button, to exit the pairing mode (red
diode will go off).
6. The function is assigned to the button. If the button
does not work, try repeating steps above.
CONNECTING
1. Connect the receiver directly to an HDMI socket in a TV,
or use included HDMI extender.
2. Connect the IR receiver to the 2,5 mm socket. The IR
receiver has to be place in front of a TV, or in a place,
where it will be visible to the remote control.
3. Connect an antenna using provided adapter.
4. Connect provided microUSB cable to the microUSB socket
of the receiver. Plug the other end of the cable to a USB
socket of the TV, or use power supply (5 V / 1 A required).
Attention: you can use any microUSB cable to power the
receiver, however it is recommended to use provided
cable, since it is equipped with the USB port for external
hard drives.
BATTERY INSTALLATION
1. Remove the battery compartment cover.
2. Place two AA batteries, according to polarity.
3. Close the battery cover compartment.
Caution:
• Do not mix old and new batteries.
• If the remote is not going to be used in a long time, store
it without batteries inside.
• Protect the remote from direct sunlight and other heat
sources.
OPERATION
1. To open up the main menu, press the menu button.
2. To navigate the menu and adjust the settings, use the
volume change and channel switch buttons.
3. To go back to previous menu, press the menu button. To
exit the menu, press the EXIT button.
QUICK INSTALLATION
If the device is turned on for the first time (or the factory
reset has been performed), the setup screen will be shown
on the screen.
• OSD language: select the interface language.
• Country: select the country.
• Antenna power: if enabled, the receiver will deliver
power to antenna output.
• Filter scrambled channels: if enabled, the receiver will
scan for free (FTA) channels only.
• LCN: Logical Channel Number; if enabled, the receiver will
assign channel numbers according to their logical order.
• After setting the options, press the Search button to
begin searching. The search will begin.
MAIN MENU
Program
Program edit
Attention: to enter this menu, input the password (default
is 000000). This menu allows for blocking, skipping,
changing channel order and adding channels to favorite
lists. To preview selected channel, press the OK button.
◦
Press the red button to move highlighted channel.
Select channel position with directional buttons. Press
the red button to disable move mode. Press the EXIT
button to save.
◦
Press the green button to skip highlighted channel.
Press the EXIT button to save. Skipped channel will not
be shown while switching channels with the next/
previous channel buttons, however it is still possible to
access the channel by inputting its number with the
numeric keypad.