16
Owner’s manual
English
SAFETY INSTRUCTIONS
Installation precautions
•
This unit is designed to operate on 9 - 15 V DC power supply. If your vehicle
does not have this system, a voltage inverter is required. The device also requires
connecting to negative of the car.
•
Choose the mounting location where the unit will not interfere with the normal
driving function of the driver. Install the unit where it does not get in the driver‘s
way and cannot injure the passenger if there is a sudden stop. DO NOT install the
unit or any cable in a location where:
◦
it may obstruct the steering wheel and gearshift lever operations,
◦
it may obstruct the operation of safety devices such as air bags
◦
it may obstruct visibility
◦
there is not enough ventilation provided
•
Avoid installing the unit where it would be subject to high temperature, such as
from direct sunlight, hot air, or a heater, or where it would be subject to dust, dirt
or excessive vibration. Do not expose this equipment to rain or moisture nor use
near strong magnetic fields. Do not handle this appliance with wet hands.
•
Make sure all the connections are executed in a proper manner. Reversed
connection will cause short circuit and damage.
•
If installation angle exceeds 30 from horizontal, the unit might not give its
optimum performance.
•
Before finally installing the unit, connect the wiring temporarily and make sure it
is all connected up properly and the unit and the system work properly.
•
If the fuse blows, check the power connection and replace the fuse with one of
the same specified rating. If the fuse blows frequently, consult an authorized
service point for check-up/repair.
• It is recommended to connect speakers with impedance of 4 Ω.
•
To prevent short circuits, cover the terminals of the UNUSED leads with insulating
tape.
•
Make sure that the ignition is off before connecting the device.
•
Make sure to connect the yellow and red power supply cables after all other
cables are already connected.
•
The heat sink becomes very hot after use. Be careful not to touch it when
removing this unit.
•
At the time of installation, be sure to fix all wires (wires both from this unit and
from the car itself) in a way that any wires cannot come into contact with heat
sinks on the rear and side of the unit.
•
Installation illustrations show a typical installation. However, you should make
adjustments corresponding to your specific car. If you have any questions or
require information regarding installation kits, consult your car dealer.
•
If you are not sure how to install this unit correctly, have it installed by a qualified
technician. Producer does not claim liability of incorrect mounting/installation
nor for inappropriate handling and use disregarding this user’s manual.
•
When mounting the unit, be sure to use the screws provided, as instructed. If
other screws are used, parts could become loose or damaged. Use only the parts
included with the unit to ensure proper installation. The use of unauthorized
parts can cause malfunctions.
•
When tightening screws or bolts, be careful not to pinch any connection cord.
•
Make sure not to block the ventilation outlets.
•
DO NOT connect the speaker leads of the power cord to the car battery; otherwise,
the unit will be seriously damaged.
•
BEFORE connecting the speaker leads, check the speaker wiring in your car.
•
Consult with your nearest dealer if installation requires the drilling of holes or
other modifications of the vehicle. In case of any doubts concerning place of
installation, contact your vehicle’s dealer. Before drilling the holes in vehicle’s
body, make sure it will not damage any electrical cables or other components.
During installation keep in mind, that any loose parts may pose danger in case of
an accident – make sure to install every piece properly to ensure safety.
