30
Owner’s manual
EN
SETTING THE CLOCK
Setting the Clock Manually
1. Set the unit in standby mode.
2. Press and hold the
CLOCK
button to activate the clock setting mode, [24]
begins to blink on the LCD.
3. Set the 12/24 hour format with the VOL+/- buttons.
4. Press the
CLOCK
button, hour indicator will blink.
5. Set the hour with the VOL+/- buttons.
6. Press the
CLOCK
button, minute indicator will blink.
7. Set the minute with the VOL+/- buttons.
8. Press the
CLOCK
button, the built-in clock starts operating.
Note:
•
To exit clock setting mode without storing, press the
STOP
button.
•
If no button is pressed in 90 seconds, the unit exits clock setting mode
automatically.
•
If a power failure occurs or the unit is disconnected from the mains, the clock
setting will be lost.
Setting the Clock Automatically
When the RDS station display the time, press and hold the
DISPLAY
button on
the remote control, the clock will automatically sync time of RDS.
Display the Clock
In any source mode, press the
CLOCK
button to display the clock.
SOUND QUALITY
Adjusting the Volume
To increase or decrease the volume, rotate the
VOLUME
control knob on the
unit or press the VOL+/- buttons on the remote control.
Mute sound
During play, press the MUTE button to mute or un-mute sound.
Note: If you change the volume or source when the sound is muted, muting is
cancelled.
Adjusting the Super Bass
you can reinforce the bass sound to maintain rich, full bass at low volume.
Press the S-BASS button on the remote control to get the effect, the “BASS”
will show in display lens. Press again to cancel the effect, the “BASS” will show
in display lens.