21
Owner’s manual
EN
In case of trapezoid distortion, use the Keystone correction knob. The projected image should
be rectangular.
Note: If the Keystone correction fails to resolve image shape, reduce the vertical height of the
projector in relation to the center of the screen.
Manual focus
The projected image may be blurry or difficult to see, due to lack of focus adjustment. Use the
focus knob adjust the image sharpness.
REMOTE CONTROL BATTERY INSTALLATION
Before first use, and whenever operational range is reduced, replace the remote control
battery:
1. Open the battery compartment.
2. Insert 2x AAA battery with correct polarity as indicated. Close the battery compartment.
Note:
•
If you are not going to use the remote control for a long time, remove the batteries.
•
Batteries contain chemical substances, so they should be disposed of properly.
• Caution: Risk of explosion! Keep batteries away from heat, sunshine, or fire. Never discard
batteries in fire.
•
Do not mix old and new batteries.
•
Please note that the operating distance of the remote control may vary depending on the
brightness of the room.
•
Any obstacles between remote control and the device may reduce operation range.
OPERATION
1. Connect the power cable to the projector and into power supply socket. The indicator light
will turn red. The projector is in standby mode. Take off the lens cover.
2. Press the power button on the control panel of the projector or on the remote control to
turn on the projector.
3. If the projected image has a distorted shape or is blurry, use the Keystone correction or
focus knobs to achieve optimum image.
4.
Connect input signal device with an appropriate cable or a USB flash drive. Press SOURCE
button on the remote control or “S” button on the control panel. A window with selection
of inputs will be displayed. Select appropriate.
Note: producer does not guarantee compatibility with every external device!
!
