![background image](http://html.mh-extra.com/html/krown/starplus-standard/starplus-standard_instruction-manual_2005009013.webp)
TAKING CARE OF YOUR STARPLUS STANDARD
Starplus Standard is designed for indoor use only. Do not set the unit in direct sun
light. It will damage the LCD which is not covered under the manufacturer
warranty.
CLEANING:
Unplug the Starplus Standard and use only a damp cloth to clean up the
outside of the housing. Never use liquid or aerosol cleaner to spray direct
to the display or body of the phone. Keep the StarPlus Standard from dust
or moisture sources.
BATTERIES:
Replace the backup batteries once a year or after a power outage to keep
StarPlus Standard in good performance.
TROUBLESHOOTING:
Q: My StarPlus Standard does not ring.
A: Check the ringer selector to make sure it is not in the OFF position.
Adjust the ring volume to HI or LOW for your comfort.
Q: My speed dial memory is erased.
A: The memory of the Starplus Standard is saved by the power of the
phone line. There is a power interruption at the telephone center or your
Starplus Standard has been disconnected from the phone line longer
than 30 minutes. It will erase the memory of the Starplus Standard
REPAIR:
Please pack your Starplus Standard in the original shipping carton with a
note describing the problem you have and send it to:
Krown Manufacturing, Inc.
ATTN: Technical Department
3408 Indale Road, Fort Worth, TX 76116
2
11
NOTICE:
The Canadian Department of Communications label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective, operational, and safety requirements.
The department does not guarantee the equipment will operate to the user’s
satisfaction. Before installing the equipment, the user should ensure that it is
permissible to be connected to the facility of the local telecommunication
company. The equipment must also be installed using an acceptable method
of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations. Repairs
to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alteration
made by the user to this equipment or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment. Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines, and internal metallic
water pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
soon as possible.
Notice: The LOAD NUMBER (LN) assigned to each terminal device denotes
the percentage of the total load be connected to a telephone loop which is
used by the device to prevent overloading. The termination on a loop may
consist of a any combination of devices subject only to the requirement the
the sum of the load numbers of all devices does not exceed 100.
SAVE THESE INSTRUCTIONS
ADDITIONAL SAFETY NOTES FOR
CANADIAN USERS
CHAPTER 5
Summary of Contents for StarPlus Standard
Page 1: ...STANDARD INSTRUCTION MANUAL 1st Edition TM ...
Page 15: ...m ...