5
6
1
2
3
4
7
8
9
10
1. MIC INPUT
For connecting low impedance dynamic & condenser (self -powered)
microphone through 1/4” plug, either in balanced or unbalanced mode.
Refer to “Plugs Wiring Details” 1a & 1b on page 7 of this manual.
2. LINE
INPUT
For connecting signal sources like CD players, Keyboards, etc. through a
6.3mm stereo phone jack, either in balanced or unbalanced mode.
Refers to “Plugs Wiring Details” 2a, 2b, and 3 on page 7 of this manual.
3. CLIP LED
This RED LED lights up to indicate that either the input signal is
overloading the input circuit or the GAIN control setting is high e nough to
distort the signal. Both conditions can be overcome by appropriate
adjustment of GAIN control. Please ensure that this LED is NOT
continuously ON.
4. GAIN CONTROL
The input level of both the Mic & Line signals can be adjusted by this
control. It provides a gain range of more than 45dB.
5. BASS CONTROL
It is used to obtain 12dB cut or boost (shelving type) at 100Hz as center
frequency.
6. MID CONTROL
It is used to obtain a 12dB cut or boost (shelving type) at 2kHz as center
frequency.
7. TREBLE CONTROL
It is used to obtain 12dB cut or boost (shelving type) at 10kHz as center
frequency.
8. PAN CONTROL
The signal of mono input channels is distributed into LEFT & RIGHT line
outputs. The PANORAMA (PAN) control is used to adjust the relative
levels of the L & R outputs of this distributed signal.
9. EFFECT CONTROL
For routing the signal to the built-in digital effect processor in desired
proportion.
10. CHANNEL FADER
This slide volume control adjust the level of pre -amplifier mono signal to
panning action.
4
KMX-8.2/12/2
Summary of Contents for KMX-8.2
Page 2: ...KMX 8 2 12 2 ...
Page 7: ...KMX 8 2 12 2 7 ...
