Pull the wires forwards to the control box and
fasten the wires to the moving system, the
connection pole and the bottom of the cara-
van until they are safely fastened.
IMPoRTanT: The wires must not be tight-
ened so much that they break when the mov-
ing system motor is moved forward towards
the tires.
The wires are pulled through the floor and are
installed on the control box according to the
electrical diagram, paragraph 5. Use rubber
passage for the hole in the floor and seal it
afterwards with sealer.
IMPoRTanT:
Check the following measures:
1. The tire pressure is controlled.
2. The roller on the moving system has the
same height as the hub of the wheel (max.
difference 45 mm.).
3. Distance between roller and tyre is
exactly 20 mm.
4. Distance between moving system gear-
box and tyre, when rollers are driven into
the tyres, must be minimum 10 mm.
5. There is a minimum distance of 130 mm.
from the surface of the road to the lower
edge of the moving system.
When the moving system is adjusted cor-
rectly and placed according to the above
measures, bolts and fittings can be tightened
as illustrated below.
The bolts on the connecting pole are tight-
ened. The moving system is now installed.
14 Installation and user manual
Summary of Contents for Mover KG2M 2011
