Manual KC-32 and KC-52 Nako
17
6.
Installation and Initial Operation
The operator can perform the installation and commissioning.
The table has to fulfil certain requirements:
-
Horizontal and flat
-
Not slippery
-
Table height between 600 and 900 mm
After placing the cutter on the table, plug in the machine in the intended outlet.
The mains plug have to be viewed and easily accessible at any time by the oper-
ator.
Before you do that, make sure that the required specifications on the label are
fulfilled. In case they do not match, do not plug in the machine or turn it on. In this
case, call the responsible customer service.
The outlet has to comply with the CEE 7/7 standards.
Initial Operation
Before the first use make sure you cleaned the cutter. Follow the instructions in
chapter “7 Use and Operating” passage cleaning.
Check the following points with slicing disks not installed.
-
Check if the engine stops with his rotation, if you fold up the pressure
plate and remove the lid.
-
Check that the cutter cannot be turned on when the lid is not on the bowl
or the pressure plate is folded up.
-
Check whether the correct direction of rotation. The knife needs to be
rotate against the clockwise direction
.
In case the machine is not working properly, it needs to get fixed by your customer
service.