The device must not be disconnected from the power supply during the fan operation - wait until
the heater has cooled down. The heater switches off automatically. Please note that after the
device has switched off, the cast iron bowl maintains a higher temperature for some time
(depending on the ambient temperature) and heater cannot be fired up again until it cools
d
!
9.
Operation
CAUTION
oil must not be poured into the fuel tank during device operation. oil must not be poured into the furnace and
it must not be fired up if the furnace chamber or bowl are still hot!!! always wait until the burner plate has
cooled down entirely.
failing to follow the above instructions may result in an uncontrolled ignition of oil fumes and scalding. it
may also cause destruction of cast iron elements!!!
Starting
While starting the device, the user may stand on the left or right side or in front of the device
Fill the fuel tank with oil (e.g. used oil) if necessary
Check whether the feeding pipe (burner) of the device is pushed into the device housing (if not, push it)
Insert the power plug in the power socket (240vac / 50Hz) the POWER led lights up
Lift the top cover of the heater up and remove the combustion chamber cover. Then, take the deflector out
(if necessary, thoroughly clean the combustion bowl, the base which it is placed on and the entire
combustion chamber)
Check whether the furnace bowl is cool and clean and pour 500 ml of fuel or diesel oil & Install the deflector
Fire the oil up using paper crumbled into a ball - set it on fire and throw onto the furnace bowl, using the
supplied pickup tool
Replace the combustion chamber cover, fastening it with locks, and close the top cover
Press the Start button on the control panel (the Run led starts to blink)
After about 10-15 minutes, depending on the room temperature, the fuel pump and the fan will activate. The
Pump led comes on at this time and will blink for 30 minutes The heater will start to operate on the minimal
power, regardless of the position of the power regulating knob (30 kW; combustion at ca. 3 l/h).
After 30 minutes, it will be possible to regulate the heater’s power with the regulating knob. [ie: If you want
more heat you may now turn the regulating know fully clockwise] If the knob, at start-up, was in another
position than minimum, the device will automatically start operating with the power set by the regulating
knob position after 30 minutes. Each press of the Stop button and restarting with the Start button during its
operation time will cause the heater to reenter the firing up phase.
Stopping
The heater is switched off by pressing the Stop button on the control panel, which switches off the fuel pump. The
heater fan operates until the furnace temperature drops below 35°C . When this happens, the heater returns to the
Stop phase. The control panel will have the Power led on at this time.
