7
Due to continued development. specifications may change without notice.
Seismix 1 V6.0: Specifications
Bass Driver
Amplifier Power
Amplifier S/N
Distortion
Line Level Inputs
Frequency Range
Output
Auto Power On / Off
Phase Select
Filters
Enclosure Type
Dimensions
Material
Finish
Weight
Nominal 200mm (8”) diameter paper cone driver, 38mm long
throw voice coil, developed for high level, low frequency rein
-
forcement
300 watts RMS, 600 watts maximum instantaneous power
>85dB (input to speaker)
<0.2% - @ 150 watts RMS
Left Input (mono)
300mV RMS for maximum output
Left + Right Input (stereo)
150mV RMS for maximum output
27Hz - 200Hz (-6dB) in room response
116dB maximum SPL in room response
15 minute delay before switching to standby after no input signal
0° to 180° continuously variable (relative to input signal)
Lowpass filter 50-200Hz 2nd Order
Highpass filter to limit driver excursion below 26Hz
Bass reflex, down-firing vent
375mm high (inc. feet) x 295mm wide x 320mm deep
17mm MDF
Vinyl or lacquered timber veneer
11kg
SPECIFICATION AND FEATURES
Additional Features
Symmetrical Vent
The Seismix subwoofer enclosure features
Symmetrical bass reflex venting, where the
vent exhibits the same flare radius internally
and externally. This lowers subwoofer
distortion and serves to reduce vent
turbulence or “chuffing” at high drive levels.
Clipping Protection
When faced with a signal peak which is in
excess of what the Seismix can accurately
reproduce, a limiter circuit activates to reduce
the level of the signal once it passes the
preset threshold. This permits the Seismix
to perform at high levels with only a mild
reduction in the signal’s dynamic content.
Fault Protection
In the unlikely event that the amplifier
experiences a fault, the status led will flash
red. If the fault persists please contact your
dealer to arrange a warranty claim or repair.
Warranty
5 years warranty applies to the cabinet and
speaker.
3 year warranty applies to the amplifier and
related internal electronics.
Refer to the details on the warranty card
supplied.
Queries
If you have any queries regarding the Seismix
Subwoofer, or any other Krix product, please
contact your nearest Krix retailer or Krix
directly. Contact details are on the back cover
of this booklet.
Nominal 275mm (11”) diameter paper cone driver, 50mm long
throw voice coil, developed for high level, low frequency rein
-
forcement
300 watts RMS, 600 watts maximum instantaneous power
>85dB (input to speaker)
<0.2% - @ 200 watts RMS
Left Input (mono)
300mV RMS for maximum output
Left + Right Input (stereo)
150mV RMS for maximum output
22Hz - 200Hz (-6dB) in room response
122dB maximum SPL in room response
15 minute delay before switching to standby after no input signal
0° to 180° continuously variable (relative to input signal)
Lowpass filter 50-200Hz 2nd Order
Highpass filter to limit driver excursion below 26Hz
Bass reflex, front vented
450mm high (inc. feet) x 360mm wide x 410mm deep (inc. grille)
17mm MDF
Vinyl or lacquered timber veneer
18kg
Seismix 3 V7.0: Specifications
Bass Driver
Amplifier Power
Amplifier S/N
Distortion
Line Level Inputs
Frequency Range
Output
Auto Power On / Off
Phase Select
Filters
Enclosure Type
Dimensions
Material
Finish
Weight
