Seite 5 © Krick Modelltechnik, Germany, June 2015
18. Parts 67 to 72. Fix in position the
seats and back supports as shown on
drawing section C-C. The seat and back
supports should be varnished.
19. Parts 73 to 74. Carefully assemble
and glue the two sets of steps. Satin
varnish when dry.
20. Parts 76 to 78. Fix the doors to the
removable cabin. Fix on the door
handles.
21. Parts 79 to 81. Assemble and fix in
place the battery holder as shown on the
main drawing.
22. Parts 82 to 84. Assemble the vent
pipe. Paint and fix in position.
23. Parts 85 to 95. Pre Paint and stain as
necesssary all the mast
components.
Taper the mast as required until the lamp
fit in the position shown. Mount the mast
in the base support lock the mast in
position using two pins 92. See the main
drawing for the
mast assembly. Drill
the mast for the boom. The boom end is
drilled and
apiece of
brass
wire
inserted. The wire is the inserted into the
mast.
24. Parts 96 to 102. All the small fittings
can be painted and fixed in the positions
indicated on the main drawing. Drill a hole
in the deck for fixing the flag staff and
epoxy glue in position.
25. Parts 104 to 106. These components
should be fitted as shown
on
the
drawing to your radio control servo.
Stickers and letters
The letters are cut from weatherproof self
adhesive foil. Cut out the full word from
the foil and then tear off the rest material
around the letters. To leave the letters in
exactly the same distance to each other,
when removing the support material, glue
some tape over the letters, which you can
tear off later. The letters do not need to
be covered 100%. It is advisable to leave
the upper or lower edges of the letters
free for exact positioning of the letters.
Then carefully tear off the support
material and place the letters exactly into
place. Finally remove the tape carefully
from the letters.
Klaus Krick Modelltechnik
Industriestrasse 1
D-75438 Knittlingen
E-Mail:
