Seite 1 © Krick Modelltechnik, Germany, June 2015
Felix Building Instructions
Art. No. 20300
1. Assemble the boat stand from parts
1-2-3 as shown on the small plan.
2. Prepare the hull by trimming as shown
on the small plan Drawing 1. Carefully
remove the excess material sand
carefully down to the final height of 5mm
and shape the bow as
shown.
3. Lightly sand the inside
of the hull to provide a key
for the deck 5. Fit the deck
and sand if required to
ensure a snug fit. When
this is achieved Epoxy glue
the deck in position. (See hull sections
BB & CC for position.)
For the following sequence refer to the
main drawing
4. Parts 6-7. Fit the engine cover,
coamings and rear access hatch
coamings under the lower deck.
5. Part 9. Fit the rear upper deck support
and glue.
6. Part 10. Fit the seat supports and
glue.
7. Part 11. Check and fit the rear deck
hatch.
