6 unload filament:do as the Item 2,then press unload filament button ,the filament will move out
(double click the button to unload filament automatically)
7.press temperature increase button and unload filament button at the same time to switch
ABS/PLA mode
8. replace nozzle set:remove the screw on the top, open the cover ,then pull out the nozzle ,
9. the pen will enter standby mode after 2 minutes no operation,and press the loading filament
button to wake it up.
10.do not touch the nozzle during working
Note
1.Heating time may be affected by environmental temperature
2.The filament end should be cut correctly before loading
3.Recommend to unload the filament after finish drawing
Trouble shooting
please follow the below instruction in case of any defect
default
reason
solution
Screen can not be powered
on
The power adapter or plug cord
defective
Repair or replace the power adapter
Motherboard defective
Repair or replace the motherboard
Socket lead off
sold the socket
No filament come out
from nozzle
Nozzle blocked
Replace the nozzle set
Temperature is not high enough
Replace the nozzle set or adjust the temperature
No working temperature
Replace the nozzle set or check the motherboard
Gear slips
Back wire, cleaning gear, cut off the damaged
supplies after the re loading
fail to load filament
unload filament and cut the end of filament well
Motherboard defective
Repair or replace the motherboard
No working temperature
Heating part defective
Replace the nozzle set
