Warning!
1. this equipment is suitable for children over 8 years old and adult.Children is only
allowed to use under adult guardianship
2. the nozzle is with high temperature ,do not touch it by hand
3. it is strictly prohibited to input any other material into the filament loading hole
4. prohibited to use the power adapter provided by other company
5. prohibited to use the filament provided by other company,cause different parameter of
filament
6. keep the pen away from water
7. keep the pen in a safe place ,where the children can not reach
Operation instructions
1.connect AC/DC adapter to AC power socket and 3D pen DC power socket, when the LCD
screen and red light are powered on ,it means power connected
2.press the filament loading button,it starts to heat,then the screen will display the
temperature,and the green light will flash ,when it reaches the preset temperature ,
the green light will stop flashing,it means it is ready for loading filament
3.insert the 1.75mm filament into the "filament loading hole",Keep pressing the "filament
loading button",the material will be loaded . Hold till plastic material
comes out from the nozzle ,it means the filament is ready.(press the button twice can load the
filament automatically, press the button again to exit automatic mode)
4.temperature adjustment:press the temperature increase and decrease button to adjust the
temperature,temperature range is 60°C-230°C
5.speed adjustment :press the speed increase and decrease button to adjust temperature,totally 6
levels(the LCD screen will display the current speed level
)
