Rev. Date: 3/14/18
Page 8
MODEL #500
ASSEMBLY
Prior to packing, your machine has been assembled and tested to assure quality performance. However, to
safeguard against damage in shipping, certain items are packaged separately within your carton and will need
assembly.
BLOWER DOOR:
(See illustration A)
This unit has Blower Door and Filter inside hopper. Install the Blower Door and Filter on machine and secure with
Filter Clips. (Blower Filter must remain in Blower Door.) An appropriate size hose is attached to the blower door
input tube and the other end is located elsewhere to provide clean air to blowers. A fine screen, acting as a filter,
over end of hose eliminates accumulation of unwanted debris. This eliminates frequent cleaning of the blower
filter. (Frequent inspection of input hose is recommended.)
POWER CORDS:
(20-30 amp twist lock inputs only)
Female receptacle(s) need to be wired properly to main power cord(s). (For 240 volt 60 hz. see illustration F and
consult electrician for assistance.) Units shipped to European countries will have standard (2) two prong 230V
16 amp plugs supplied. Units shipped overseas to other than Europe do not have plugs and receptacles on input
cords due to the varying electrical plug configurations in different countries, unless provided by Krendl agents or
suppliers.
ASSEMBLY OF OPTIONS:
(See illustration B) Options below are available on the model #500 machine.
5" Wheel Package: (standard or heavy duty)
Attach two swivel casters on airlock end of machine for increased mobility. Mount rigid casters on control end
with the hex bolts provided.
Bushing Reducer: (2 1/2" output)
Bushing reducer inserts into output tube of airlock. Press reducer firmly against shoulder and tighten two
hold-down bolts to secure unit in place. The bushing reduces the size of opening to hose at its source,
providing a more consistent feed while preventing hose plugs. (Standard output tube on model #500 is
3".)
Hopper Extension:
If Hopper Extension is not shipped mounted on machine, place
Hopper Extension on top of machine.
(illustration A)
(illustration B)
Summary of Contents for 500
