KREMLIN REXSON
- 2 -
N° : 578.065.110-UK-1202
SUCTION VALVE
Unscrew the suction valve (30).
(If the cylider (21) remains attached to the
suction valve, unscrew both parts, then hold
cylinder (21) by inserting a rod into the
cylinder holes designed for this purpose).
The ball (32) is secured on the valve by
means of a circlips (33).
Clean the parts.
Reinstall the suction valve (30) and the seal
(24). Replace the parts if it is necessary.
CYLINDER
In order to make easier the disassembly, a hole is drilled in the cylinder (21) at each end.
Depending on the part that it is unscrewed first, insert a rod into one of these holes to unscrew the
other part.
When reassemblying, make sure the two seals (24) are installed.
EXHAUST VALVE AND MOBILE PACKING
Unscrew the cylinder (21) and pull it downwards.
Unscrew the exhaust valve (29) by holding the piston (22).
Remove the ball (25) and the mobile packing (cup seal 23).
Clean all the parts and replace them by changing the seals if it is necessary.
UPPER TIGHTNESS SEAL
Unscrew the 4 screws (26).
Remove the tightness seal (27) by pulling the exhaust flange (20) downwards.
Change the tightness seal (27), the O Rings (8 and 24).
Remount the parts in the reverse order of the disassembly sequence.
Comply with GT seal orientation order.
