KREMLIN REXSON
- 2 -
N° : 578.032.110-UK-1410
UPPER PACKING
Separate the piston rod from the motor and the
piston (3) from the fluid section.
Unscrew wetting-cup (4) by means of the wrench
supplied with the pump.
Pull piston (3) upwards to remove upper packing
seals (21 and 22).
Reinstall parts in reverse order. Be certain seals
(21 and 22) are installed properly (
direction
,
order
and assembly
dimension
).
Tighten wetting-cup (4).
After reassembly, fill up the pump with solvent and
increase pressure to maximum in the fluid section.
Then stop the pump and open exhaust valve to
depressurize.
Retighten wetting-cup (4) by means of the wrench,
in order to be in accordance with the opposite
drawing.
PTFE G
REVERSING BLOCK (MOTOR) (REFER TO DOC. 573.087.040)
Guards (air motor cover, coupling shields, housings …) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards
Disassemble cover by removing the screw.
Dissociate female yoke from reversing block lever.
Dismount reversing block by removing screws.
Reinstall the new reversing block in the reverse order of the disassembly sequence.
31.85 mm ±0.5
CAUTION :
The number of spirals must equally be distributed on each
fastening parts in order to get the above dimension.
Before reassemblying the different components :
-
Clean the parts with the appropriate cleaning solvent.
-
Install new seals if it is necessary after having lubricated them with PTFE grease.
-
Install new parts if it is necesssary.
