KREMLIN REXSON
- 2 -
N° : 578.164.110-UK-1204
UPPER PACKING
Separate motor piston rod from hydraulic piston (3).
Unscrew wetting-cup (4) by means of the wrench
supplied with the pump.
Pull piston (3) upwards to remove upper packing
seals (21 and 22) from upper packing (18).
Reinstall parts in reverse order. Be certain seals (21
and 22) are installed properly (
direction
,
order
and
assembly
dimension).
Tighten wetting-cup (4).
After reassembly, fill up the pump with solvent
and increase pressure to maximum in the fluid
section. Then stop the pump and open exhaust
valve to depressurize.
Retighten
wetting-cup
(4)
by means
of
the
wrench, in order to be in accordance with the
opposite drawing.
REVERSING BLOCK (REFER TO DOC. 573.045.050)
Guards (air motor cover, coupling shields, housings …) have been designed for
safe use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards
Disassemble cover (32) by removing CHc screws (33).
Dissociate female yoke (12) from reversing block lever (9).
Dismount reversing block by removing screws (10 and 8).
Reinstall the new reversing block in the reverse order of the disassembly sequence.
31.85 mm ±0.5
CAUTION : The number of spirals must equally be distributed on each fastening parts in
order to get the above dimension.
Before reassembling :
-
Clean the parts with the appropriate cleaning solvent.
-
Install new seals if it is necessary after having lubricated them with PTFE grease.
-
Install new parts if it is necessary.
PTFE G
