continued
7
20.
Screw each foot/washer assembly into the four screw holes located on the
bottom of the loudspeaker.
21.
Spin the washers counterclockwise up the shaft of each foot to secure the foot.
22.
Carefully invert the loudspeaker so that it is resting on the feet.
23.
Remove the top foam end cap and sleeve.
2 people needed
You are ready to position the Resolution 1 or Resolution 2 in the listening area. See
Placement, on page 8.
To continue the unpacking process for the Resolution C, after completing Steps
1-4 on page 5:
6.
The loudspeaker is lying on its side. The sides of the loudspeaker are inset into
foam pads. These cannot be removed while the loudspeaker is in the box.
Remove the moveable foam pads protecting the front and back of the loud-
speaker.
7.
Kneel down and grasp the bottom side foam pad.
8.
Carefully slide the loudspeaker out and away from the inner and outer cartons.
The loudspeaker is still on its side, and the foam pads still protect the loud-
speaker sides.
two people needed
9.
Set the inner and outer cartons aside.
10.
Remove the top side foam pad from the side of the loudspeaker.
11.
Open the band that secures the protective sleeve around the loudspeaker.
12.
Gently slide the sleeve down, toward the bottom side foam pad.
13.
Carefully rotate the loudspeaker so that the bottom of the cabinet is on the
floor.
14.
Remove the remaining foam pad and the protective sleeve.
2 people needed
You are ready to position the Resolution C in the listening area. See Placement,
on page 8.
Krell Resolution 1, 2, 3, and C Loudspeakers
(SECTION TWO: Unpacking and Placement continued)
