SETUP
WARNING:
!
Disconnect saw from power before making any adjustments.
ATTENTION
!
The saw blade is aligned perpendicular to the saw
base and the bevel indicator set at 0° at the factory. To ensure accurate
cuts, check the alignment and the position of the bevel indicator as
indicated
below
.
ATTENTION
!
Both set screws must be turned the same amount in
the same direction.
Calibrate the bevel scale
(
1
) Verify that the -1° bevel overrides are
in the 0° position. (See Bevel cuts in
the Using the saw section.)
(
2
) Adjust the cut-depth stop to full depth.
(
3
) Loosen the front and rear bevel locks.
(
4
) Remove splinter guard from blade
housing, then plunge the saw to full
depth and hold.
(
5
) Check the blade-to-base angle
with a square.
(
6
) Adjust the angle by turning the
set screws.
(
7
) Tighten the front and rear bevel locks.
(
8
) Set the bevel indicator to the zero mark
and reinstall the splinter guard.
1
3
2
3
1
6
6
5
4
Speed Control
(
1
) Turn the speed-control dial to adjust blade speed.
1
SAW MOTOR SPEEDS
Dial Setting Revolutions Per Minute (RPM)
1
2,000
2
2,200
3
3,000
4
3,900
5
5,000
6
5,500
MAX
6,000
7
8
7
Summary of Contents for ADAPTIVE CUTTING SYSTEM
Page 79: ...NOTES REMARQUES NOTAS ...
