KRAUSMANN 8352, Operation Manual

Page: 18 / 20

18
8352 KRAUSMANN POWER TOOLS
Wear ear defenders
Wear safety goggles
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for amateur use covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For
possible faults during the warranty period, you
should address your issue to the retail shop from
which the purchase was made.
7. Warranty
Terms of warranty
The tool has been used properly and for the
purpose for which it was purchased.
T he tool presents a problem that is due to
faulty material and manufacturing.
Incapability of the tool to perform according
to the technical specs provided.
Damages are not covered by the warranty that are
due to causes such as:
Wear due to improper use.
Partial or total disassembly.The tool’s shell
must be disassembled only by personnel
authorised by the official distributor.
Damage due to overloading.
Usage of incorrect or incompatible accessory.
B ad maintenance from the operator or any
other third party.
Wear that was induced by external factors or
rogue particles (dust, debris etc.)
Wear due to non compliance with the
instructions in this manual.
The warranty is valid only when:
English | EN
6. Maintenance
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned using a soft DRY brush
and most effectively with compressed dry air.
Always wear safety goggles when cleaning
tools with compressed air.
C ertain cleaning agents and solvents damage
plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.The brushes and commutator in your
tool have been engineered for many hours of
dependable service. To maintain peak efficiency
of the motor, we recommend every two to six
months the brushes be examined.
All of the bearings in this tool are lubricated with
a sufficient amount of highgrade lubricant for the
life of the unit under normal conditions. Therefore,
no further lubrication is required.
Store the tool, operating instructions and
where necessary the accessories in the original
packaging. In this way you will always have all the
information and parts ready to hand parts ready
to hand.
B D
E
C
fig 7
In case there is a need for a repair after the
warranty period has expired, we will provide
the best possible attention to repair the tool
successfully.
8. Repair / Servicing
If, during the warranty period, there is a fault that
can not be repaired from the authorised service
department, the tool will be replaced without any
extra cost.