WIRELESS
ROUTER
150MBPS
ADSL2/2+
WIRELESS ROUTER 150MBPS ADSL2/2+ User
Guide
26
Figure 4-11
Router Local IP:
These are the IP settings of the LAN interface for the device. These
settings may be referred to as Private settings. You may change the LAN IP address if
needed. The LAN IP address is private to your internal network and cannot be seen on the
Internet.
IP Address:
Enter the Router’s local IP Address, then you can access to the Web
-based
Utility via the IP Address, the default value is 192.168.1.1.
IP Subnet Mask:
Enter the Router’s Subnet Mask, the default value is 255.255.255.0.
Dynamic Route:
Select this option to specify the RIP (Routing Information protocol)
version for LAN interface, including
RIP1
,
RIP2-B
and
RIP2-M
. RIP2-B and RIP2-M are
both sent in RIP2 format, the difference is that RIP2-M using Multicast, while RIP2-B
using Broadcast format.
Direction:
Select this option to specify the RIP direction.
None
is for disabling the RIP
function.
Both
means the ADSL Router will periodically send routing information and
accept routing information, and then incorporate them into routing table.
IN only
means
the ADLS router will only accept but will not send RIP packet.
OUT only
means the
ADLS router will only send but will not accept RIP packet.
Multicast:
Select IGMP version, or disable the function. IGMP (Internet Group Multicast
Protocol) is a session-layer protocol used to establish membership in a multicast group.
The ADSL ATU-R supports both IGMP version 1 (
IGMP v1
) and
IGMP v2
. Select
“
Disabled
”
to disable it.
IGMP Snoop:
Enable the IGMP Snoop function if you need.
26
Manual
www.kraun.it
Summary of Contents for 150Mbps ADSL2/2+
Page 17: ...14 Manual www kraun it ...
