Kramer Yarden 6-C, User Manual

Page: 11 / 20

8 Yarden 6-C - Installing the Yarden 6-C Closed-back Ceiling Speakers
Figure 4: Mounting the Yarden 6-C
2. Place the tile rails on the tile and snap them into the two tabs on the C-ring.
Align the rails so that the ends extend over the T-channel grid.
3. Insert a screw through each tab on the C-ring to secure the rails.
4. Connect the speaker wires to the appropriate connector terminals:

PIN 1 and PIN 2 are connected internally and are positive (+)

PIN 3 and PIN 4 are connected internally and are negative (-)
Screw the hold-down screws on the connector until tight, using a small
screwdriver.
You can connect the speakers in the two following possible layouts:

Wiring in parallel : connect the amplifier directly to each of the
speakers. When one input connector is removed, subsequent
speakers will remain connected (see Figure 3 )

Daisy-chaining : connect the wire pair (+ and -) of the speaker to the
subsequent s and -. When one input connector is removed,
subsequent speakers will be disconnected (see Figure 3 )
5. Plug the connector into the socket in the terminal cup of the speaker (see
Figure 5 ).
6. Run the wires through the opening in the input terminal cover and then
connect to the speaker terminal block connector.
T-channel Grid
Support Ring
Screws
Ceiling Tile
Tile Rails
C-ring