# Feature
Function
Lights Yellow
Device falls back to default IP address.
6 CH+ / CH-
Click the recessed CH buttons to configure the channel ID. The channel ID is shown on the
display panel. On the US model, access to these buttons requires removal of the frame.
7 RESET
Press and hold for 10 seconds to reset the device to its factory default values. All LEDs flash.
On the US model, access to this button requires removal of the frame.
8 Display Panel
Shows the number of the ethernet channel used by the device when transmitting the signal.
9 AUDIO IN 3.5mm Mini Jack
Connect to an audio source.
#
Feature
Function
10
LAN MEDIA 1G(PoE)
RJ-45 Port
Connect for streaming either directly to a decoder or via LAN, with or without commands.
WP-SW2-EN7
is powered by PoE delivered to this port, unless the optional 20V DC connector is
used.
11
20V/6A DC Connector
Connect to the power adapter (purchased separately).
12
LAN SERVICE 1G RJ-
45 Port
Use optionally for physical separation between AV and command streams to separate LAN for
security and reliability purposes.
13
Ring Tongue Terminal
Grounding Screw
Connect to grounding wire (optional).
14
RS-232 3-pin Terminal
Block Connector
Connect to an RS-232 device to use as a Gateway and bi-directional serial control signal
extension (even when no AV signal is extended).
Step 3: Mount WP-SW2-EN7
Insert the device into the in-wall box (note that first you need to connect the RS-232 and LAN/POE RJ-45 Connector cables
and/or power) and connect the parts as shown in the illustration:
EU/UK Version
US-D Version
DECORA® design frames are included in US-D models.
