Step 3: Install WP-EN6
Insert the device into the in-wall box (note that first you need
to connect the LAN/POE RJ-45 Connector cable and/or
power) and connect the parts as shown in the illustration:
DECORA® design frames are included in US-D models.
DECORA® is a registered trademark of Leviton
Manufacturing Co., Inc.
We recommend that you use a
US-D
2 gang US electrical
junction box (or their equivalent).
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
WP-EN6
. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the
WP-EN6
.
RS-232 Configuration
Grounding the
WP-EN6
(Optional)
RS-232 Control
1.
Connect the ring tongue terminal to the building grounding point wire
(a green-yellow, AWG#18 (0.82mm2) wire, crimped with a proper
hand-tool is recommended).
2.
Insert the M3x8 screw through the toothed lock washer, the tongue
terminal and the washer in the order shown above.
3.
Insert the M3x8 screw (with toothed lock washer ring tongue terminal
and washer) into the grounding screw hole and tighten the screw.
Baud Rate:
115,200
Data Bits:
8
Stop Bits:
1
Parity:
None
For optimal performance, use the recommended Kramer cables available at
www.kramerav.com/product/WP-EN6
Using third-party cables may cause damage!
Step 5: Connect power
When accepting power from a PoE provider, there is no need to connect the 12V DC power supply.
Otherwise, connect the 12V power adapter (sold separately) to the device and plug the power supply into the mains electricity.
Safety Instructions
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
•
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
•
To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the bottom of the unit.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
