Using the WP-210A XGA/Audio Line Driver
7
5.2 Operating the WP-210A XGA/Audio Line Driver
To operate your
WP-210A
XGA/Audio Line Driver
:
1. Connect your XGA source (for example, a laptop’s digital graphics card)
to the Input HD15F connector and to the AUDIO Input
3.5mm mini jack,
for example, using a Kramer C-GMA/GMA cable (VGA HD15M +Audio
jack to VGA HD15M +Audio jack)
1
.
Alternatively, you can connect an XGA source to the Input HD15F
connector, and a separate audio source to the AUDIO Input.
2. Connect the HD15F Loop connector to a local monitor, if required.
3. Push in the ID Bit button to set to ON.
4. Adjust
2
the output signal level and/or cable compensation equalization
level, if required, as well as the right
3
and/or left
3
audio output signal levels.
1 Not supplied. The complete list of Kramer cables is on our Web site at http://www.kramerelectronics.com
2 Use a screwdriver to carefully rotate the Potentiometer, adjusting the appropriate level
3 Insert a screwdriver into the small hole and carefully rotate it, trimming the appropriate audio output level
