![background image](http://html1.mh-extra.com/html/kramer/vs-88hn/vs-88hn_user-manual_2001456021.webp)
18
VS-88HN - Operating the VS-88HN 8x8 HDMI Matrix Switcher
6.9
Connecting via Ethernet
You can connect to the
VS-88HN
via Ethernet using either of the following methods:
Directly to the PC using a crossover cable (see
Section
6.9.1
)
Via a network hub, switch, or router, using a straight-through cable (see
Section
6.9.2
)
After connecting the
VS-88HN
to the Ethernet port, configure your local Ethernet port
by following the instructions in the Ethernet Configuration (K-LanConfigurator) guide
available from
http://www.kramerelectronics.com/support/product_downloads.asp
or from the Downloads section of the
VS-88HN
Web page.
Note
: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.9.1
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
VS-88HN
directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VS-88HN
with the factory configured default IP address.
6.9.2
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the
VS-88HN
to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
6.10
Upgrading the Firmware
For instructions on upgrading the firmware see “
Upgrading the
VS-88HN
Firmware
Using the STC Software
”.
i