Kramer Electronics Ltd.
VS-3232DN-EM
– Input / Output Card Hardware Installation Instructions
72
Figure 18: Card Handles
3. Remove the blanking plate from the slot and store it for possible future use.
4. Remove the new card from its shipping box and anti-ESD bag.
5. Holding the card by the upper and lower handles, align the card with the plastic guide
6. Slide the card into the chassis until the front of the card makes contact with the
connector inside the chassis.
7. Press the card firmly into the slot until the connector plate is flush with the rear panel of
the chassis and the connector is fully seated.
8. Using a Phillips screwdriver, tighten the retaining screws at the top and bottom of the
card to secure it to the chassis.
9. Power on the
VS-3232DN-EM
.
10. Power on the peripheral devices.
