38
VS-1616D - Using the Configuration Menus
Y indicates that a load is attached and X indicates that no load is detected
on the relevant output.
3. Do one of the following:
•
Press BREAKAWAY to exit the Config Menu
•
Wait approximately 15 seconds for the operation to time out
•
Press MENU to move to the next Config Menu option
7.2.4
Config Menu—Setting Output Port Parameters
This option sets port-specific parameters. Ports that show an X have no parameters
available to modify. Ports that show a 0 have parameters available to modify. The
parameters that are available, such as, audio balance, depend on the type of card
installed and whether the card is an input or an output card. Tables listing output
cards and their parameters can be found at the end of this section.
To set parameters for a port:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
2. Press MENU until a display is shown similar to the following:
OUT:
01
02
03
04
05
06
07
08
09
10
11
SET:
O
O
X
X
O
O
O
O
X
X
X
X indicates that there are no modifiable parameters for the associated port
and 0 indicates that there are modifiable parameters for the associated port.
3. Press TAKE to enter the list of ports.
The cursor flashes on a selected port.
4. Select the required port to modify using the left and right arrow buttons.
