RS-232 Control / Protocol 3000
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format:
ASCII
Stop Bits:
1
Example (Set display mode to Picture in Picture): #Y0,110,1<CR>
Default Ethernet Parameters
Full Factory Reset
To reset the IP settings to the factory
reset values, power cycle the device
while holding in the Ethernet Reset
button, located on the rear panel of the
unit
Front panel
buttons
Turn power off. Turn power on again while holding the
RESET TO XGA/720p front panel button. The LEDs blink.
Full factory reset is complete once the LEDs cease to blink
and react normally
Note that full factory reset includes Ethernet reset as
well.
IP Address:
192.168.1.39
OSD
Factory Reset through the Misc. menu item
Subnet mask:
255.255.000.000
Web pages
Factory reset via the Device Settings embedded Web page
Default gateway:
000.000.000.000
Protocol 3000 Use "Factory" command or #Y 0,771,1<CR>
TCP Port#:
5000
UDP Port#:
50000
Maximum UDP Ports:
10
Maximum TCP Ports:
4
Web page password
1234
Step 7: Select an input via the contact closure remote control pins
Remote Control
To select input 3, momentarily connect the 3 PIN to the G PIN.
Remote Control
To select PIP input 8, connect the PIP PIN to the G PIN and, within 3 seconds,
momentarily connect the 8 PIN to the other G PIN.
Step 8: Control the display via HDKat
To activate port tunneling:
1. Set the dedicated port tunneling Ethernet connection port
type and port number through which the
VP-770
will be
passing RS-232 signals (TCP and 5050, by default).
2. Use the UART command to set the communication
parameters (9600, 8, N and 1, by default).
