Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
VP-770
.
The Mic can be set to a condenser or
dynamic mic. When set to condenser,
48V of phantom power will be
available.
Wiring the RJ 45 Connectors
This section defines the TP pinout, using
a straight pin-to-pin cable with RJ 45
connectors.
EIA /TIA 568B
PIN Wire Color
1
Orange / White
2
Orange
3
Green / White
For HDBT cables, it is recommended
that the cable ground shielding be
connected/soldered to the connector
shield.
4
Blue
5
Blue / White
6
Green
7
Brown / White
8
Brown
To achieve specified extension distances, use the recommended Kramer cables available at
www.kramerav.com/product/VP-770
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to
VP-770
and plug it into the mains electricity.
Safety Instructions (See
for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
•
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
•
To ensure continuous risk protection, replace fuses only according to the rating specified on the product label which located on the bottom of the unit.
Step 6: Operate VP-770
Enter the OSD menu via the MENU button on the front panel or the IR remote control transmitter. Select a menu item and set
parameters as required. Sub-menus include: Input, Audio, Process, Picture, Enhance, Scale, and Misc.
By default, the output resolution is set to Native, the
VP-770
is triggered to read the EDID of the main display and change the output
resolution value according to the native resolution of the display.
If you cannot see any images, verify that the display, TV, or
projector is in good working order and is connected to the
VP-770
. If you still don't see an image, press and hold the
RESET TO XGA/720P button for 2 seconds to reset the
output to XGA or 720p resolution.
Notable menu items include: Output Resolution, EDID Input Setting, HDCP Input Setting, Emergency Alert.
