8
VP-690 - Connecting the VP-690
5
Connecting the VP-690
Always switch off the power to each device before connecting it to
your
VP-690
. After connecting your
VP-690
, connect its power and
then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
To connect the
VP-690
, as illustrated in the example in
Figure 3
, do the following:
1. Connect an SDI source (for example, a non linear editor) to the SDI IN BNC
connector.
2. Connect the SDI LOOP BNC connector to an SDI acceptor (for example, an
SDI display).
3. Connect an HDMI source (for example, a DVD player) to the HDMI 1 VIDEO
INPUT connector.
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the
VP-690
via a DVI-HDMI adapter. When using this adapter, you can
connect the audio signal via the terminal block connector
4. Connect a computer graphics source to the PC 1 15-pin HD VIDEO INPUT
connector.
5. Connect a composite video source (for example, a composite video player)
to the CV 1 VIDEO INPUT RCA connector.
6. Connect a component video source (for example, a component video player)
to the COMP 1 P
R
, P
B
and Y, VIDEO INPUT RCA connectors.
7. Connect the audio input signals to the AUDIO INPUT terminal block
connectors, as required (not shown in
Figure 3
).
8. Connect the RGBHV VIDEO OUTPUT BNC connectors to an RGBHV
acceptor (for example, an RGBHV display).
!
i
