Connecting the VP-23N Presentation Switcher
13
2. Connect the acceptors to a projector
1
as follows:
The composite video CV OUT BNC connector to the composite video
input of the projector
The s-Video Y/C OUT 4p connector to the s-Video input of the
projector
The VGA/UXGA UXGA OUT HD15F connector to the VGA/UXGA
input of the projector
3. Connect the appropriate balanced audio sources and acceptors (not shown in
Figure 4).
4. Connect the MASTER OUT terminal block connector, if required (not shown
in Figure 4; see section 7.3).
5. Connect the SPKR OUT block connector to a pair of loudspeakers, by
connecting the left loudspeaker to the “L+” and the “L-” terminal block
connectors, and the right loudspeaker to the “R+” and the “R-” terminal block
connectors.
Do not Ground the loudspeakers
.
6. Connect the UXGA CAT5 OUT twisted pair connector (see section 6.2) to a
line receiver (for example, the
TP-120
XGA Line Receiver
2
, which is
connected to a remote display).
7. Connect a dynamic or a condenser microphone
3
, if required, to the MIC IN
XLR connector.
8. As an option, you can connect a PC and/or controller to:
The RS-232 port (see section 6.3)
The RS-485 port (see section 6.4)
The ETHERNET (see section 6.5)
9. Connect the unit to additional machines (if required) via the RS-485 port (see
section 6.6).
10. Connect the power cord.
1 In this example a projector is used, but you can also connect separate outputs such as displays, video recorders and so on
2 The receiver receives the CAT5 signal, decodes it and outputs it to a VGA acceptor
3 Use the Con / Dyn switch (refer to the rear panel, item 2 in Figure 2) to select a dynamic microphone or a condenser
