![background image](http://html1.mh-extra.com/html/kramer/vm-2hdt/vm-2hdt_quick-start-manual_2000998001.webp)
VM-2HDT, VM-3HDT
Quick Start
P/N: 2 9 0 0 - 3 0 0 8 5 9 QS
Rev: 2
Scan for full manual
VM-2HDT, VM-3HDT Quick Start Guide
This guide helps you install and use your
VM-2HDT, VM-3HDT
for the first time.
www.kramerav.com/downloads/VM-2HDT, VM-3HDT
to download the latest user manual and check if
firmware upgrades are available.
Step 1:
Check what’s in the box
VM-2HDT
or
VM-3HDT
HDBT DA/Extender
4 Rubber feet
1 Bracket set
1 Power adapter and cord
1 Quick start guide
Step 2: Get to know your VM-2HDT, VM-3HDT
This section defines the
VM-3HDT
.
VM-2HDT
is identical but has 2 HDBT OUT connectors (OUT 1 and OUT 2).
#
Feature
Function
1
PROGRAM Mini USB Connector
Use to send RS-232 commands.
Connect to a PC to perform firmware upgrades (via K-Upload) and work with the
EDID Designer. K-Upload and EDID Designer can be downloaded from our Web site
at:
To use the mini USB port, you need to download and the Kramer USB driver from our
Web site at:
www.kramerav.com/support/product_downloads.asp
and install it.
2
EDID SETUP Button
Press to capture one of the output EDIDs or the default EDID to the input EDID.
3
IN LED
Lights when an active input signal is detected.
4
LINK LEDs (1 to 3)
Lights when a link is established with the receiver (
VM-2HDT
: 1 to 2).
5
OUTPUT LEDs (LOOP and 1 to
3)
Lights when a remote active output acceptor (sink) is detected on the LOOP or
HDBaseT receiver that is connected to the output (
VM-2HDT
: LOOP and 1 to 2).
Flashes when a non-HDCP acceptor is connected to the output and the input is
HDCP-encrypted (the content is displayed for only a few seconds).
6
ON LED
Lights when the unit receives power.
7
INPUT HDMI
™
Connector
Connects to the HDMI source.
8
LOOP OUT HDMI Connector
Connect to a local monitor or a daisy-chained distributor, for example, a
VM-4HDT
.
9
HDBT OUT Connectors (1 to 3)
Connect to an HDBT acceptor, for example
TP-580R
(
VM-2HDT
: 1 to 2).
10
IR 3.5mm Mini Jack
Connect an IR sensor for sending IR signals to a remote device (for example, a
projector connected to an HDBT receiver).
Or
Connect an IR emitter (attached to a local device) for receiving IR signals from the
device’s IR remote control via HDBT.
11
RS-232 3-pin Terminal Block
Connect to a serial controller to control a remote device that is connected to the RS-
232 port of the HDbaseT receiver.
12
SETUP 8-way DIP-switch
Used to set the IR and RS-232 command behavior.
13
SETUP 4-way DIP-switch
Always keep all four DIP-switches UP (off).
14
5V DC Connector
Connects to the 5V DC power supply.