KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VM-100CB
6
5 Connecting the VM-100CB
This section defines how to connect the
VM-100CB
. In particular, how to
connect:
A single unit (
1:10 Video Component Distributor
), see section 5.1
Several
units, see section 5.2
5.1 Connecting a Single VM-100CB Unit
To connect a single
VM-100CB
unit (
1:10 Video Component Distributor
), do
the following
1
:
1. Connect a component video source (for example, an HDTV satellite
receiver) to the BNC INPUT connectors.
2. Connect the 10 component video output connectors
2
to up to 10
component video acceptors.
3. Leave the LOOP BNC connectors unconnected, and set all three
underside TERMINATION switches: B-Y, R-Y, and Y to 75 (for
termination: slide to the left).
Note: if a loop connection is required, for example, to a local monitor,
plug it into the LOOP BNC INPUT connectors and set all three underside
TERMINATION switches: B-Y, R-Y, and Y to HI-Z (for looping: slide
to the right).
4. Connect the power cord
3
(not illustrated in Figure 3).
Figure 3: Connecting a VM-100CB Unit
1 Switch OFF the power on each device before connecting it to your VM-100CB. After connecting your VM-100CB, switch
on its power and then switch on the power on each device
2 If less than 10 outputs are needed, connect only those outputs of the VM-100CB that are required, and leave the other
outputs unconnected
3 We recommend that you use only the power cord that is supplied with this machine
