Kramer Electronics Ltd.
TP
‑
580TD, TP
‑
580RD – Defining the TP
‑
580RD DVI Line Receiver
5
Defining the TP
‑
580RD DVI Line
Receiver
Figure 2:
TP
‑
580RD
DVI Line Receiver
#
Feature
Function
IN
LED
Lights green when an active far-end source DVI input signal is detected via the
HDBaseT link (a DVI signal is detected from a source device connected to the
HDBaseT transmitter that is connected to this input).
OUT LED
Lights green when an DVI output signal is detected.
LINK
LED
Lights green when an HDBT link is established with the HDBaseT transmitter.
ON
LED
Lights green when the device receives power.
HDBT IN RJ-45
Connector
Connect to the RJ-45 HDBT OUT connector on a transmitter (for example,
TP
‑
580TD
).
DVI OUT
Connector
Connect to a DVI acceptor.
PROG/NORMAL
Switch
Slide to PROG to upgrade to the latest Kramer firmware via RS-232 or slide to
NORMAL for normal operation.
RS-232 3-pin
Terminal Block
Connector
Connect to a laptop to control
TP
‑
580RD
or perform firmware upgrade.
Connect to a controlled device (for example, the DVI OUT acceptor) to control it
from a remote serial controller (for example,
SL-240C
) that is connected to
TP
‑
580TD
.
IR 3.5mm Mini
Jack Connector
Connect to an external infrared emitter / sensor.
12V DC Power
Connector
12V DC connector for powering the unit.
