KRAMER: SIMPLE CREATIVE TECHNOLOGY
Configuring the TP-310A UXGA Line Receiver/DA
8
6
Configuring the TP-310A UXGA Line Receiver/DA
This section describes how to:
•
Connect the
TP-310A
(see section
6.1
)
•
Connect additional
TP-310A
units (see section
6.2
)
•
Wire the CAT 5 LINE IN/LINE OUT RJ-45 Connectors (see section
6.3
)
•
Wire the RS-232 connector (see section
6.4
)
6.1 Connecting a single TP-310A UXGA Line Receiver/DA
You can use the
TP-310A
with a UXGA/audio/data line transmitter such as the
Kramer
TP-123
1
To
configure a
TP-123
/
TP-310A
UXGA/Line Receiver – DA system
. You can connect a single
TP-310A
to up to 10 receivers, and
up to five
TP-310A
units can be connected to increase the number of outputs to
46.
2
as
illustrated in the example in
Figure 3
, do the following
3
1. On the
TP-123
, connect:
:
A UXGA source (for example, a laptop’s graphics card) to the XGA
IN 15-pin HD computer graphics video connector and an audio source
to the Audio IN 3.5mm mini jack, for example, using a Kramer
C-GMA/GMA cable (VGA 15-pin HD + audio jack to VGA 15-pin
HD + audio jack)
4
An RS-232 cable with a 9-pin D-sub connector at one end to the
laptop, and a 2-PIN terminal block connector at the other end to the
TP-123
RS-232 port
2. On the
TP-310A
, connect the:
UXGA OUT 1 15-pin HD computer graphics video connector to the
UXGA acceptor 1 (for example, a plasma display), and the Audio
OUT ANALOG 1
3.5mm mini jack connector to the analog audio
connector on the acceptor. If required, connect the RS-232 G and TX1
terminal block connector to the RS-232 port on the acceptor
UXGA OUT 2 15-pin HD computer graphics video connector to the
UXGA acceptor 2 (for example, a display), and the Audio OUT
S/PDIF 2
RCA connector to the digital audio acceptor (for example,
an AV Receiver)
1 Refer to the separate user manual, which can be downloaded at:
http://www.kramerelectronics.com
2 Using up to 300ft (100m) of UTP cabling
3 Switch OFF the power on each device before connecting it to your TP-310A. After connecting your TP-310A, switch on its
power and then switch on the power on each device
4 Not supplied. The full list of Kramer cables is on our Web site at
http://www.kramerelectronics.com
. Alternatively, you can
connect an XGA source to the XGA IN 15-pin HD connector, and a separate audio source to the AUDIO IN 3.5mm mini jack