KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-102xl UXGA to RGBHV / Audio Interface
6
5 Connecting the VP-102xl UXGA to RGBHV / Audio Interface
To connect your
VP-102xl
, as the example in Figure 5 illustrates, do the
following
1
:
1. Connect your UXGA source (for example, a computer) to the UXGA IN
HD15F connector and to the AUDIO IN
3.5mm mini jack, for example,
using a Kramer C-GMA/GMA cable (VGA HD15M +Audio jack to VGA
HD15M +Audio jack)
2
.
2. If required, connect a local display to the UXGA LOOP HD15F
connector.
3. Connect the BNC OUTPUT connectors (RED, GREEN, BLUE, Hs and
Vs) to the RGBHV acceptor (for example, a projector).
4. Connect the unbalanced stereo AUDIO OUT 3.5mm mini jack to an
acceptor (for example, power amplifier and speakers).
5. Connect the 12V DC power adapter (wall transformer) to the 12V DC
socket and connect the transformer to the mains electricity.
6. If required, adjust
3
the:
Cable compensation equalization level
Left and right audio output signal level
7. If required, set the ID Bit to ON.
1 Switch OFF the power on each device before connecting it to your VP-102xl. After powering up your VP-102xl, switch on
the power on each device
2 Not supplied. The complete list of Kramer cables is on our Web site at http://www.kramerelectronics.com
3 Use a screwdriver to rotate the potentiometer, adjusting the appropriate level
