KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the TBUS-2 Connection Bus
8
5.2 Inserting the TBUS-2 through the Cut-Out Opening
To install the
TBUS-2
, do the following:
1. Carefully insert the unit into the prepared opening.
2. Take the support brackets under the table and place them into the support
bracket grooves at the desired height (on both the front and rear sides of the
unit).
3. Make sure that the upper outer rim is situated parallel to the edge of the table.
4. Insert the table securing screw through the holes in the support brackets and
tighten them until they reach the table surface (from underneath).
5. Secure the cables.
Do not keep the cord too tight or too loose.
6. Connect the appropriate cables to the mounted Kramer inserts from
underneath.
Once you have connected the unit to mains power and connected the proper
cables, you may use the unit.
5.3 Installing the Required Kramer Inserts
You can install the Kramer inserts before or after installing the
TBUS-2
.
By default, the mounting surface includes a power socket (different power
sockets are available, see Figure 4), and six blank plates for optional video,
audio, telephone and network connectors.
Any of the Kramer inserts mounted to the connecting surface can be
rearranged or removed and replaced with Kramer inserts
1
or connector
modules for interfacing A/V type signals.
To mount a Kramer insert or connector module, do the following:
1. Unscrew the two screws that fasten the blank plate to the connecting surface
and remove the blank plate.
2. Place the required Kramer insert over the opening, insert the two screws to fix
the Kramer insert in place, and tighten them.
1 The complete list of Kramer inserts and module connectors is on our Web site at http://www.kramerelectronics.com
