![background image](http://html.mh-extra.com/html/kramer/spk-c621-k/spk-c621-k_user-manual_2002100012.webp)
8
Yarden 8-C - Installing the Yarden 8-C Closed-back Ceiling Speakers
Figure 4: Mounting the Yarden 8-C
2. Place the tile rails on the tile and snap them into the two tabs on the C-ring.
Align the rails so that the ends extend over the T-channel grid.
3. Insert a screw through each tab on the C-ring to secure the rails.
4. Connect the speaker wires to the appropriate connector terminals:
PIN 1 and PIN 2 are connected internally and are positive (+)
PIN 3 and PIN 4 are connected internally and are negative (-)
Screw the hold-down screws on the connector until tight, using a small
screwdriver.
You can connect the speakers in the two following possible layouts:
Wiring in parallel
: connect the amplifier directly to each of the
speakers. When one input connector is removed, subsequent
speakers will remain connected (see
Figure 3
)
Daisy-chaining
: connect the wire pair (+ and -) of the speaker to the
subsequent s and -. When one input connector is removed,
subsequent speakers will be disconnected (see
Figure 3
)
5. Plug the connector into the socket in the terminal cup of the speaker (see
Figure 5
).
6. Run the wires through the opening in the input terminal cover and then
connect to the speaker terminal block connector.
T-channel Grid
Support Ring
Screws
Ceiling Tile
Tile Rails
C-ring