Kramer RTBUS-21, User Manual

Page: 12 / 20

RTBUS-21xl - Installing the RTBUS-21xl 9
9
5 Installing the RTBUS-21xl
To install the RTBUS-21xl perform the following steps:
1. Drill a hole in the table (see Section
5.1
).
2. Install the power socket (see Section
5.2
).
3. Insert the unit through the hole and secure the unit to the table (see
Section
5.3
).
4. Connect the cables (see Section
5.4
).
5.1 Drilling a Hole in the Table
To drill an opening in the table:
1. Using any standard cup bit drill with a diameter ranging from 111mm to
114mm (4.37in to 4.49in), drill a hole in the table in the desired location.
The thickness of the table should be 3in (76mm) or less.
2. Clean the table surface.
Take care not to damage the table. Kramer Electronics is not
responsible for any damage caused to the table.
i
!