8
PT-2C - Connecting the PT-2C
5.2
EDID loading/storing
The EDID DIP-switch 1 determines the behavior of EDID on the device.
5.2.1
The Pass-through Mode
In the pass-through mode (DIP-switch 1 set to on), the EDID of the connected
output (a display in the following examples) is automatically loaded to the
PT-2C
.
If the display is replaced, the
PT-2C
captures the new EDID from the new display.
Any change in the output automatically changes the EDID that is stored in the
PT-2C
.
When disconnecting the output the last EDID remains stored in the
PT-2C
.
5.2.2
The EDID Lock Mode
When in the Lock mode (DIP-switch 1 set to off), the current EDID is locked and
remains unchanged even if the display is replaced on the output.
When in the lock mode the audio setup is determined by the DIP-switch 3 Audio
setup.
You can connect a PC to the EDID DESIGNER/F/W UPDATE Mini USB port to
modify the EDID via the Kramer EDID designer software.
Note that when using EDID designer to modify the EDID (in the Lock
mode), the DIP-switch 3 status is ignored.
5.2.3
Setting the default EDID
You can set the
PT-2C
to its EDID default value.
To set the default EDID
:
1. Make sure the
PT-2C
is set to the Pass-through mode
2. Disconnect the output.
3. Set DIP-switch 1 to the Lock mode (off).
The default EDID is loaded
