PT-2C - Connecting the PT-2C
7
5.1
Configuring the PT-2C
The 8-way Program DIP-switch on the rear panel is used to configure the
PT-2C
according to the following table.
Note that all the DIP-switches are set to off (up) by default.
DIP
Feature
Function
1
Lock the EDID
On (down) — EDID pass-through mode
Off (up) — EDID Locked
When EDID is locked, the audio parameters are
set as defined by DIP-switch 3. In pass-through
mode, the DIP-switch 3 setup is ignored
The Audio DIP-switch (3) setup is implemented only upon setting DIP-
switch 1 to off (up), locking the EDID
2
Deep color
On—Passes the deep color parameters (down)
Off—Limits deep color to 8 bits per color (up)
3
Audio setup
On—Passes the audio parameters (down)
Off—Limits the audio to 2-channel LPCM (up)
This setup is enabled only after DIP-switch 1 is set
to Off (EDID locked).
4
HDCP operation
On—Passes HDCP (down)
Off—HDCP off (up)
When On, if the output supports HDCP, the input
declares HDCP support. It will then handle HDCP
on the output and input actively. If the output does
not support HDCP then the input will not support
HDCP.
When Off, the device does not support HDCP on
its input, even if HDCP is detected on the output.
5
Color space
On—Passes color space (down)
Off—Forces RGB color space (up)
6/7
Set output 5V shutdown
6
Off
Off
On
On
7
Off
On
Off
On
Delay before 5V output cut-off
Always on
5s
1m
15m
The
PT-2C
can
power off the HDMI 5V output to let the connected device enter the
sleep mode if there is no source connected. The power off delay time is controlled by
DIP-switches 6 and 7 (0 = up/Off; 1 = down/On)
8
Reserved (always set to off)
