Kramer Electronics Ltd.
KDS-SW2-EN7
– Using KDS-SW2-EN7 Embedded Web Pages
22
Defining Signal Loss Timeouts
KDS-SW2-EN7
enables setting timeouts if a signal is lost or a cable is disconnected.
To define signal loss timeouts:
1. In the Navigation pane, Select
AV
. The Auto Switch tab in the AV Settings page appears
.
2. Set the following timeouts (in seconds):
▪
Signal Loss Switching Delay
– From the time
KDS-SW2-EN7
detects a signal loss,
to when it switches to a different input (default 10).
▪
Signal Detection Delay
– From the time
KDS-SW2-EN7
detects a signal, to when it
switches to that input (default 0).
▪
Cable Plug Delay
– From the time
KDS-SW2-EN7
detects a cable connected, to
when it switches to that input (default 0).
▪
Cable Unplug Delay
– From the time
KDS-SW2-EN7
detects a disconnected cable
to when it switches to a different input (default 0).
▪
Signal Loss Switching Power Off Delay
– From the time
KDS-SW2-EN7
detects a
signal loss to when the 5V power output turns off (default 900).
▪
Signal Loss Switching Manual Override Delay
– From when
KDS-SW2-EN7
detects a signal loss on manual override to when it switches to a different input
(default 10).
3. Click
SAVE
.
Signal loss timeouts are defined.