![background image](http://html1.mh-extra.com/html/kramer/kds-10/kds-10_quick-start-manual_2001579002.webp)
Step 4: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your
KDS-10
.
Connecting audio output
Connecting audio Inputs
Connecting the audio
output to a balanced
stereo audio acceptor:
Connecting the audio
output to an unbalanced
stereo audio acceptor:
Connecting a balanced
stereo audio source to the
balanced input
Connecting an unbalanced
stereo audio source to the
balanced input
For optimal performance, use the recommended Kramer cables available at
www.kramerav.com/product/KDS-10
Using third-party cables may cause damage!
Step 5: Connect power
Connect the power cord to
KDS-10
and plug it into the mains electricity.
Safety Instructions (See www.kramerav.com for updated safety information)
Caution:
•
For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.
•
There are no operator serviceable parts inside the unit.
Warning:
•
Use only the power cord that is supplied with the unit.
•
Disconnect the power and unplug the unit from the wall before installing.
Step 6: Operate KDS-10
Operate
KDS-10
via:
•
Remotely, by Mini USB serial
commands transmitted by a
touch screen system, PC, or
other serial controller
•
Embedded web pages via the
Ethernet
RS-232 Control / Protocol 3000
Baud Rate:
115,200
Parity:
None
Data Bits:
8
Command Format: ASCII
Stop Bits:
1
Example: (Switch video input 2 to output 4): #V 2>4<CR>
Default Ethernet Parameters
IP Address:
192.168.1.39
UDP Port #:
50000
Subnet Mask:
255.255.0.0
TCP Port #:
5000
Gateway:
0.0.0.0.
Default Username:
Admin
Default Password:
Admin
To control via the Web pages:
1. Connect the
KDS-10
Ethernet port.
2. Access the embedded Web pages.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.