102
K-CONFIG - Assigning the Controlled Devices to Master and Auxiliary Device Ports
You can also choose to show the unused ports by checking the Show unused ports box:
Figure 189: Project Navigator – Display of the Assigned and Unassigned (unused) Drivers
7.2
Setting the Functionality of the GPI/O Port
The GPI/O (General Purpose Input/Output) port functionality can be defined in the Port Manager as follows:
•
Analog Input, Digital Input and Digital Output modes
•
With or without the internal pull-up resistor
In the K-CONFIG software this term is referred to as Pullup (as opposed to “pull-up”)
•
Threshold setup
Note that only the GPI/O ports on the Master room controller can be activated. The GPI/O Ports on the
auxiliary device do not appear in the port manager.
RC-74DL
GPI/O ports in the Port Manager:
Figure 190: Port Manager – Master RC GPI/O ports
To set GPI/O, do the following:
1.
Select the Master RC that includes the GPI/O feature (for example,
RC-74DL
which has two GPI/O ports).
2.
Select the
Port Manager
window.
3.
In the GPI/O.1 port, set the functionality of the port and name the port in the description box (for example,
Temperature High for Digital Input, see
You have to set the port functionality before you add commands to action lists.
Figure 191: Port Manager – Selecting Digital Input for a Temperature Sensor
4.
Select one of the options described in the following sections.
