Kramer Electronics Ltd.
DSP
‑
1
– Connecting DSP
‑
1
8
Figure 6: Internet Protocol Version 6 Properties Window
6. Select
Use the following IP Address
for static IP addressing and fill in the details as
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255
(excluding 192.168.1.39) that is provided by your IT department.
Figure 7: Internet Protocol Properties Window
7. Click
OK
.
8. Click
Close
.
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the
DSP
‑
1
to the Ethernet port on a network hub or
using a straight-through cable with RJ-45 connectors.
Control Configuration via the Ethernet Port
To control several units via Ethernet, connect the Master unit (Device 1) via the Ethernet port
to the Ethernet port of your PC. Use your PC provide initial configuration of the settings (see