Kramer DIP-31M, Quick Start Manual

Page: 2 / 4

# Feature Function
10 AUDIO OUT 3.5mm Mini Jack Connect to the unbalanced, stereo audio acceptor, (for example, active speakers)
11 ETHERNET RJ-45 Connector Connect to the LAN, (Ethernet traffic or PC controller)
12 RS-232 CONTROL 3-pin Terminal
Block
Connect to a serial controller or PC
13 RS-232 DATA 3-pin Terminal Block Connect to a serial data source or acceptor
14 PC/HDMI Remote Toggle Switch
Terminal Block
Connect to a remote switch to toggle between the HDMI and VGA inputs. Each
press cycles through the priority inputs HDMI IN 1

HDMI IN 2

PC IN or a
different priority cycle specified on the Video & Audio Settings Web page
15 Remote Contact-closure 4-pin
Terminal Block Connect to remote momentary switches to control step-in and audio volume
16 FACTORY RESET Button Short press to reboot, long press to reset the device to factory default parameters
17 SETUP 4-way DIP-switch Switches for setting the device behavior (see Step 5)
18 PROG Mini USB Connector Connect to a PC to perform a firmware upgrade
19 HDMI OUT Connector Connect to a compatible HDMI display
20 12V DC Connector Connect to the supplied power adapter
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Install the DIP-31M
Install DIP-31M using one of the following methods:
•
Attach the rubber feet and place the unit on a flat surface.
•
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to www.kramerav.com/downloads/DIP-31M .
•
Mount the unit in a rack using the recommended rack adapter
(see www.kramerav.com/product/DIP-31M ).
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your DIP-31M . For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the DIP-31M .